Troubleshooting RLM firmware update problems with the Data ONTAP CLI

You can troubleshoot a firmware update using the Data ONTAP CLI.

Steps

1. Verify the RLM is online by entering the following command at the storage system prompt: rlm status
2. Update the RLM firmware by following the instructions described in the Data ONTAP Upgrade Guide.
   Note: Verify you are using the correct filename (filename.zip) of the RLM firmware.

3. Reboot RLM by entering the following command at the storage system prompt:rlm reboot
   Note: It takes approximately one minute for the RLM to reboot.

4. If the RLM does not reboot, repeat Steps 1 through 3. If the RLM still does not reboot, contact technical support for assistance.