A B C D E F H I L M O P R S T
Index
A
- adapters
- installing expansion
- list of expansion, used in product
- removing expansion
- replacing expansion
- ATA disks, locating LEDs on
- AT-FC errors
- Aborted command, internal target failure
- Environmental sensor Element 3 not installed or failed
- Hardware error, internal target failure
- Hardware error, logical unit communication error
- Illegal request, invalid command Op Code
- Illegal request, invalid field in CDB
- Illegal request, invalid field in parameter list
- Illegal request, logical block address out of range
- Logical unit not ready, command in progress
- Logical unit not ready, manual intervention required
- Media error, address mark not found for ID
- Media error, unrecoverable read error
- Medium error, mechanical positioning error
- Medium error, record not found
- Not ready, cause not reportable
- Not ready, logical unit is in the process of becoming ready
- Recovered error, controller impending error, general hard drive failure, SMART notification.
- SES electronics Element 1 component is from a different product family
- SES electronics Element 1 failed
- SES electronics Element 1 not installed or failed
- SES electronics Element 2 failed
- Temperature sensor Element 2 failed
- Temperature sensor Element 2 not installed or failed
- Temperature sensor Element 3 failed
- Unit attention, inquiry data changed
- Unit attention, power-on occurred
- Unit attention, reset or target reset occurred
- Vendor-specific Element 1 not installed or failed
- Vendor-specific Element 2 not installed or failed
- AT-FC/AT-FC2/AT-FCX modules
- conditions for replacing
- installing
- interpreting LEDs on
- monitoring LEDs on
- removing
- requirements for hot-swapping
- AT-FCX modules
- console error messages
- hot-swapping
- audience for this guide
B
- batteries
- installing motherboard lithium
- removing motherboard lithium
- boot error messages
- Cannot initialize labels
- Cannot read labels
- Configuration exceeds max PCI space
- Dirty shutdown in degraded mode
- Disk label processing failed
- Drive %s.%d not supported
- FC-AL loop down, adapter %d
- File system may be scrambled
- Halted, firmware too old
- Halted, illegal configuration
- Invalid PCI card slot %d
- No /etc/rc
- No /etc/rc, running setup
- No disk controllers
- No disks
- No network interfaces
- No NVRAM present
- NVRAM #n downrev
- boot, troubleshooting system
C
- cards
- installing memory assembly
- removing memory assembly
- carrier
- closing the PCB
- opening the PCB
- removing the PCB
- commands
- fcstat device_map
- halt
- storage disable
- storage enable
- configurations, required SDRAM DIMM memory
- console error messages
- about startup
- AT-FCX
- cooling element, element 1 and 2
- front operation panel
- Open loop panic
- power supply
- Soft address panic
- control panel subassembly
- installing storage engine
- interpreting LEDs
- locating LEDs
- removing storage engine
- conventions
- formatting
- terminology
D
- DIMMs
- about replacing SDRAM
- installing SDRAM
- locating SDRAM
- removing SDRAM
- required SDRAM memory configurations
- disk drives
- compatibility information
- interpreting LEDs on
- locating LEDs on
- requirements for replacing
- supported models
- disk shelf IDs, explained
- disk shelves
- front panel LEDs, locating
- hot-adding to existing loop
- ID display, locating
- installing in rack
- interpreting front panel LEDs
- LED responses at startup
- removing from daisy chain
- removing from single configuration
- replacing
E
- equipment rack, installing disk shelves in
- error messages
- DS14mk2 AT, hot-adding
- See boot error messages 35
- See operational error messages 39
- See POST error messages 29, 42
- types of
- expansion adapters
- installing
- list of FRU
- list of, used in product
- removing
- replacing
F
- fan modules
- identifying failed storage engine
- installing in storage engine
- interpreting power supply LEDs on
- numbering storage engine
- removing storage engine
- formatting conventions
- front panel
- console error messages
- interpreting disk shelf LEDs on
- locating disk shelf LEDs on
- monitoring disk shelf IDs on
- FRUs
- See expansion adapters 50
H
- hot-adding
- disk shelf requirements for
- disk shelf to existing loop
- error messages about
- hot-swap of AT-FCX modules
- hot-swappable devices
- storage engine fan replacement time limit
- storage engine power supply replacement limit
I
- IDs
- disk shelf, explained
- disk shelf, locating
- monitoring disk shelf
- installation
- about POST messages during
- process tasks
- roadmap
- startup sequence for
- installation of
- AT-FC/AT-FC2/AT-FCX modules
- disk shelf into existing single-path loop
- disk shelf power supply
- disk shelves in rack
- expansion adapter
- memory card assembly
- motherboard lithium battery
- motherboard tray
- SDRAM DIMMs
- storage engine control panel subassembly
- storage engine fan module
- storage engine power supplies
L
- labels, for populating drive bays
- LEDs
- AT-FC/AT-FC2/AT-FCX modules, interpreting
- AT-FC/AT-FC2/AT-FCX modules, locating
- AT-FC/AT-FC2/AT-FCX modules, monitoring
- control panel assembly, interpreting
- control panel assembly, locating
- copper multiport GbE NIC, interpreting
- copper multiport GbE NIC, locating
- copper single-port GbE NIC, locating
- disk drive, interpreting
- disk drive, locating
- disk shelf front panel, interpreting
- disk shelf front panel, locating
- dual-port Fibre Channel HBA, interpreting Initiator mode
- dual-port Fibre Channel HBA, interpreting Target mode
- dual-port Fibre Channel HBA, locating
- fiber multiport GbE NIC, interpreting
- fiber multiport GbE NIC, locating
- fiber single-port GbE NIC, locating
- front panel, locating
- power supply fan module, interpreting
- power supply fan module, locating
- power supply, interpreting
- power supply, locating
- startup response, locating
- storage engine front panel, interpreting
- storage engine front panel, locating
- types of disk shelf
- list of storage engine FRUs
- loop
- hot-adding disk shelf to existing
- installing disk shelf in existing single-path
M
- maintenance, opening the PCB carrier for
- memory card assembly
- installing
- removing
- memory, required DIMM configuration
- messages
- about startup console
- boot error
- DS14mk2 AT error
- normal boot
- normal POST
- operational error
- modules
- installation of AT-FC/AT-FC2/AT-FCX
- integrated power supply fan
- locating LEDs on AT-FC/AT-FC2/AT-FCX
- monitoring LEDs on AT-FC/AT-FC2/AT-FCX
- removing AT-FC/AT-FC2/AT-FCX
- motherboard lithium battery
- installing
- removing
- motherboard tray, installing the
- motherboard, replacing the
O
- operational error messages
- Disk hung during swap
- Disk n is broken
- Dumping core
- Error dumping core
- Fans stopped, replace them
- Panicking
- Power supply degraded
- System too hot
P
- PCB carrier
- closing the
- opening the
- removing
- POST error messages
- -12V power bad
- 12V power bad
- 2.5V power bad
- 3.3V power bad
- 5V power bad
- BMC disable
- Boot device err
- Boot DeviceErr
- Clock batt dead
- Clock dead
- Clock error
- Clock invalid. Date reset
- Clock reset
- CPU count err
- CPU speed err
- CPU ucode err
- Env-A/B/C/D rupt err
- Env-A/B/C/D stat err
- Fan stopped
- FP button stuck
- Inv boot device
- LCD cmd stall
- LCD cursor error
- LCD data error
- LCD won't open
- Missing CF-card
- No power info
- Onboard battery low
- Overtemp alert
- PCCRD format err
- PCCRD head err
- PCCRD init fail
- PCCRD read err
- PCCRD reg error
- PCCRD seek err
- PCCRD setup err
- PCCRD track err
- Post error. Rebooting
- Pwr Sup #1 bad
- Pwr Sup #1 out
- Pwr Sup #2 bad
- Pwr Sup #2 out
- SIO error
- Unknown System
- Watchdog error
- Watchdog failed
- power supplies
- and integrated fan module
- compatibility issues between
- eror messages regarding
- error messages regarding
- installing disk shelf
- installing in storage engine
- interpreting LEDs on
- locating LEDs on
- removing from a disk shelf
- removing from storage engine
- replacing disk shelf
- replacing storage engine
- power supply error messages
- cooling element, element 1 and 2
- power supply element 1 and 2
- process, installation tasks
R
- rack, installing disk shelves in
- removal of
- AT-FC/AT-FC2/AT-FCX modules
- disk shelf from daisy chain
- disk shelf power supply
- expansion adapter
- memory card assembly
- motherboard lithium battery
- motherboard tray
- PCB carrier
- SDRAM DIMMs
- single disk shelf
- storage engine control panel subassembly
- storage engine fan module
- storage engine power supply
- replacement of
- disk shelves
- expansion adapters
- memory card assembly
- motherboard tray
- SDRAM DIMMs
- requirements
- AT-FC/AT-FC2/AT-FCX module hot-swap
- disk drive replacement
- disk shelf power supply removal
- for hot-adding disk shelves to existing loop
- power supply compatibility
- SDRAM DIMM memory
- responses
- See startup LED responses
- roadmap, installation
S
- SDRAM DIMMs
- about replacing
- installing
- locating
- removing
- required memory configurations for
- SES electronics Element 2 not installed or failed
- single-path loop, installing disk shelf in existing
- special messages to heed in guide
- startup error messages, types of
- startup LED responses
- storage engine
- front panel LEDs
- identifying failed fan subassembly in
- installing fan module in
- installing power supplies in
- installing storage engine control panel subassembly
- removing control panel subassembly
- removing fan module from
- removing power supplies from
- replacing power supplies in
- supported disk drives
- system boot, troubleshooting
- system messages
- boot
- POST
T
- tasks, installation process
- terminology in this guide
- tray, replacing the motherboard
- troubleshooting, system booting
A B C D E F H I L M O P R S T
Copyright © 1994-2007, Network Appliance, Inc. All rights
reserved.
Part No. 210-00387_E0
File: bookix.htm
Last updated: 26-Jan-2007 07:21:51