Manual Pages
Table of Contents
na_rlm - commmands for use with a Remote LAN Module (RLM)
rlm help
rlm reboot
rlm setup
rlm status
rlm test autosupport
rlm test snmp
rlm update
The rlm command is used with a Remote LAN Module (RLM), if
one is present. Using this command, you may get the status
of an RLM and test an RLM. Configuration of an RLM can be
performed by using the setup command.
- help
- Display a list of Remote LAN Module
(RLM) commands.
- reboot
- Causes the RLM to reboot. If your console
connection is through the RLM it
will be dropped. The reboot command
forces a Remote LAN Module (RLM) to
reset itself and perform a self-test.
- setup
- Interactively configure a Remote LAN
Module (RLM).
- status
- Display the current status of a Remote
LAN Module (RLM).
test autosupport Performs autosupport test on the
Remote LAN Module (RLM). The autosupport
test forces a Remote LAN Module
(RLM) to send a test autosupport to
all email addresses in the option list
autosupport.to.
- test snmp
- Performs snmp test on the Remote LAN
Module (RLM). The snmp test forces a
Remote LAN Module (RLM) to send a test
snmp trap to all traphosts set in snmp
command snmp traphost.
- update
- The RLM firmware is updated. This may
be a time consuming operation. Before
issuing this command , you need to
execute the `software install' command
to get the new firmware image. The
RLM will be rebooted at the end of
this operation.
This command only acts upon a Remote LAN Module (RLM) that
is local to the system.
rlm status
might produce:
Remote LAN Module Status: Online
Part Number: 110-00030
Revision: 32
Serial Number: 296167
Firmware Version: RLM_package_version=1.2.0
Mgmt MAC Address: 00:A0:98:01:98:D0
Using DHCP: no
IP Address: 172.22.136.61
Netmask: 255.255.224.0
Gateway: 172.22.128.1
na_setup(1), na_options(1)
Some of these commands might pause before completing while
the Remote LAN
Module (RLM) is queried. This is normal behavior.
Table of Contents
Copyright © 1994-2008 NetApp, Inc. Legal Information