Opening the PCB carrier

Reasons to open the PCB carrier

You open the PCB carrier to access the motherboard tray, memory card assembly, expansion adapters, and other FRUs.

To open the PCB carrier for access to the internal FRUs, complete the following steps, using the figure for reference.

Step	Actions
1	Shut down the storage engine by entering the following command at the console: halt Caution Always use the `halt` command to perform a clean shutdown. The LCD on the storage engine displays `Halted` when the system is halted.
2	Turn off and disconnect the power to the storage engine.
3	Put on the antistatic wrist strap and attach the grounding leash to the storage engine chassis.
4	Remove the cable management tray.
5	Loosen the three thumbscrews on the back panel of the PCB carrier.
6	Carefully pull the cam handle so that the PCB carrier slides out from the chassis until the carrier tabs click to lock the slide rails in place. The PCB carrier has a travel distance of approximately 19 inches (48.26 centimeters).